GET RX1 PRO Guia De Instalacion página 5

REMEMBER TO WORK UNDER SAFETY CONDITIONS
AND TO KEEP THE ENGINE TURNED OFF.
1.
Find the OEM ECU between
the airbox and the fuel tank.
If necessary, check on your
motorbike's workshop manual
where to find it. Press the
retainer clip of the OEM ECU
connector before pulling it: make
sure to remove the connector
without damaging it.
2.
Place and fix the support
bracket, included in the kit, to
insert GET RX1 Pro ECU.
3.
Connect GET RX1 Pro ECU to
the OEM connector. Make sure
the connector is properly plugged
in, and the retainer clip is fully
engaged.
4.
Uninstall the OEM map switch
from the handlebar, unplug the
connector from the 4-pole harness
placed on the left side of the bike,
and cover the connector with the
cap provided in GET RX1 Pro kit.
5
EN