ES
EN
FR
IT
Confirm the pins is complete upspring and locked the axle and rear wheels; if the pins are
not complete upspring, the inner rod is protruding at the same time, this is a sign that the
axle needs to be adjusted. A wrench will be needed to move the nut while keeping the
axle in a fixed position.
Please, adjust the nut of axle to increase the effective critical length from pins to nut, until
the pins are complete upspring and the inner rod is inside the axle. Please, note to check
the axles frequently during use, if find the pins can´t be upspring and/or the axles can´t
work, must replace it at once and please don´t use wheelchair when the axles are broken
or defective.
Warning: Replacement axles are not adjusted to your chair. They must be
adapted following the steps in this paragraph for a proper assembly of the
wheels. Please observe the side (R, L) during adaption.
Please note, the critical length couIdn't be longer too much than wigth of E plus
F (Figure item E, F), otherwise will cause the rear wheels shaking.
Warning: Before use wheelchair, please do confirm the rear wheels were fully
inserted and settled, otherwise maybe cause the rear wheels detaching and
personal injury and please adjust as above method.
DE
PT
NL
SWE
PL
DK
WHEELCHAIR
S220 Sevilla | S230 Sevilla