Publicidad
Gb
U
U
P
O
O
ZB
K
FIG. 4
4) Glue Dowels (U) for sleepers into Left and Right Sides (Gb&Hb).
Glue the Left Side (Gb) to the sleeper assembly. Insert the dowels in the sides into the holes in the
sleepers. Fasten in place with #8 x 1¾" Pan Head Screws (O) through the holes in the notches. See
FIGURE 4. Repeat for the Right Side (Hb).
Attach the Base (K) to the lower front Sleeper (I) by inserting six #8 x 1¼" Black Screws (P) through
the sleeper into the back of the base and fastening securely. The bottom of the base must be fl ush
with the bottom of the sides.
Attach a Right Angle Bracket (ZB) to the Base (K) and each side approximately one inch from the
bottom of the unit fl ush with the front edge using #6 x 5/8" Undercut (type 17) Screws (R). See FIG-
URE 4.
M
N
P
P
N
FIG. 5
5) Slide the Top (J) down so that the four Cam Connectors (M) go into the four holes in the top of
the Sides. Insert the Cam Housings (N) and tighten securely. Insert six #8 x 1¼" Black Screws (P)
through the holes in each sleeper into the Top and fasten securely. See FIGURE 5.
Attach a Right Angle Bracket (ZB) to the Top (J) and the Sides about 1" behind the front sleeper
with #6x5/8" Undercut (type 17) Screws (R).
Page 6 — 586Wb — Rev. 6/07
O
P P
P
I
P
P
P
P
P
O
P
P
O
U
O
P
P
N
P
Hb
R
U
R
J
R
P
ZB
M
ZB
R
Publicidad
