Hitachi PC-ARFP1E Manual De Instalación Y Funcionamiento página 26

LOUVER SETTING
8 LOUVER SETTING
This setting is available only for the indoor unit adopting the individual louver.
The each louver angle can be set individually as following procedure.
1 Press " " (menu) during the normal mode (when unit is
operated). The menu will be displayed.
2 Select "Louver Setting" from the menu and press "OK". The
louver setting will be displayed.
3 Select "Louver Setting" from the louver setting and press "OK".
4 Select the indoor unit to change the louver direction by
pressing " " and press "OK".
(This screen is NOT displayed when the number of indoor unit
connected with the remote control switch is 1 (one). In this
case, (5) will be displayed).
5 Press " " and select the louver direction. The selected
louver is opened and the other louvers are closed.
6 Press " " (menu) while "?" (help) is pressed. The confirmation
screen will be displayed.
7 Select "Yes" and press "OK". (5) will be displayed after the
setting change is confirmed. If "No" is selected and "OK" is
pressed, the screen will return to (5).
* Regarding "Louver Setting", the louver selected at (5) will be
set as "Nº1" and the other louver Nº will be changed clockwise
automatically as shown in the figure.
?
N O T E
This "Louver Setting" is NOT available when the 2 (two) remote control switches are used in the same H-LINK (including combination with PC-ARFP1E
+ PC-LH3A (Wireless Remote Control Switch)).
18 PMML0404A rev.1.1 - 06/2022
Menu 15:10(Fri)
Louver Setting
Louver Open/Close
VENTI
Total Heat Exchanger SET
Motion Sensor Setting
SEL. ENT.
OK
Louver Setting
Louver Setting
Cancel INDV Louver SET
SEL. OK ENT.
Louver Setting
01-01
01-02
01-03
01-04
Select unit to set.
SEL. ENT.
OK
Louver Setting:01-03
1 2 3
Adjust air direction & louver angle
SEL. ADJ ENT.
OK
Louver Outlet Setting:01-03
Change louver outlet number?
(2 1, 3 2, 4 3, 1
Yes No
SEL. ENT.
OK
02
/
03
RTN.
RTN.
RTN.
4
RTN.
4)
RTN.