Druck Dry PTC 200 Manual De Instrucciones página 5

Power supply voltage range, power consumption and fuse value for each model:
Model
Dry PTC 200
Dry PTC 700
Liquid PTC 165(i)
Liquid PTC 255(i)
3.2 Safety
Before using the equipment, make sure that you read and understand all the related data. This
includes the applicable local safety procedures, the User Manual and instructions for the
accessories/options/equipment you are using it with.
HOT SURFACE
the metal block/liquid bath, make sure that it has cooled down sufficiently. There
is a risk of severe burns from the metal block/liquid bath and the test specimen.
WARNING
explosive atmospheres.
Safety Valve. The calibration bath is equipped with a pressure safety valve,
which is activated at approximately 2.5 bar (36 p.s.i). This can result in
pressurized hot steam being released. Always unscrew the transport cover
before using the calibration to avoid excessive pressure build up.
Ventilation Ports. Do not block or restrict airflow to the ventilation ports located
on the top and the bottom of the equipment.
RISK OF ELECTRIC SHOCK
to a protective earth during operation.
If malfunctioning, the equipment must be returned to a Druck Service Centre.
If the equipment is not used as specified by the manufacturer, the built in
protection afforded by the equipment may not operate as designed.
Always use the Druck supplied power supply cord with the equipment.
The IEC power connector is the main disconnection and isolation device. The
front switch must not be used to isolate the device.
Do not position the equipment so that it is difficult to operate the disconnecting
device.
Mains Voltage
110/230 V ac
110/230 V ac
110/230 V ac
110/230 V ac
Risk of Severe Burns. Prior to transporting or contact with
Explosive Atmosphere. Never operate the equipment in potentially
Power
555 W
1000 W
375 W
1000 W
Make sure that the equipment is connected
English–Dry PTC / Liquid PTC Calibrators | 3
Fuse
T6.3H250V
T10H250V
T6.3H250V
T10H250V
Copyright 2022 Baker Hughes Company.