mspa Nest Manual Del Propietário página 11

NOTE: Always keep the spa cover on to minimize heat loss when heating the water.
Make sure the cover, and mostly its side facing water, will not come into contact with the ground or any other dirt when not in use.
Covers shall be cleaned inside and out periodically using a suitable solution that includes adequate disinfection (e.g. 10ml/l of free Chlorine).
CONTROLLER OPERATION
LED Display
Heater Button
Bubble Button
- Adjust the bubble level by pressing
the button (L1: 300W, L2: 500W, L3: 720W
Up Button
UVC Button
LED Display
°C
°F
Once powered-up, press the RESET on the PRCD. The LED displays the current water temperature automatically.
NOTE: The actual water temperature may vary from the temperature displayed on the LED screen by as much as approximately 1°C.
HEATING
HEATER
1. Press the HEATER button to turn the heating system on/off. When the light above the heat button is red, the heating system is activated.
HEATER
When the light is green, the water is at the set temperature and the heating system is at rest.
20-40°C
2. Pressing the UP or
UP
temperature setting (from 20°C to 40°C ). The new and desired temperature setting will remain on the LED display for 3 seconds to confirm the
new value.
NOTE: The default temperature is 40°C.
NOTE: If the heating system is turned on, the filtration system will automatically start.
NOTE: When the water temperature is below 1°C (33.8°F), the anti-icing system will be activated automatically to heat the water to 3°C (37.4°F).
IMPORTANT: The following conditions will lead to slow water heating
●
An ambient temperature lower than 10°C (50°F).
●
An outdoor wind speed above 3.5-5.4m/s (8-12mph).
●
If the air bubble function is activated when the heater is on.
●
If the spa cover is not properly in place when the heater is on.
Buckle Lock Operation
DOWN button will cause the LED to flash. When it is flashing you can adjust the water to the desired
DOWN
Lock
11
Unlock
Filter Button
Timer Button
Down Button
OZONE Button