EN
2.3 - BEFORE OPERATING
Make sure that the machine is only used
by who is familiar with the instruction
manual.
To ensure a safe operation, you must:
� Check the power tool before using
it. Check that all the accessories are
correctly assembled and attached to
the machine and in good conditions.
Never use damaged accessories;
� Check if all nuts and screws are
properly tightened. It is important to
check the machine regularly in order to
ensure its security and efficiency;
� After assembling the accessories
and before using the equipment,
test it at full speed chargeless for a
few seconds. Verify if there are any
misalignments in the moving parts or
any condition that may affect its normal
operation. Check if every moving parts
are rotating properly, without abnormal
noises nor sparks;
� Check if the safety devices are
in perfect conditions and working
correctly. Never use the machine if
any safety device is missing, inhibited,
damaged or worn;
� Make sure that the switch is off when
you plug in the power cable. If the
button is damaged or doesn't allow to
control the machine's operation, it must
be repaired or replaced in order to
prevent an unintentionally start;
� Perform all the needed adjustments
and in case of doubts ask your
distributor for assistance.
2.4 - WHILE OPERATING
Keep other people away from
the workspace. Never use the
machine
if
animals
particularly children, are nearby.
The clothing worn while operating
the machine must be appropriate and
tight, such as a work coverall. Do not
28
wear loose clothing or jewelry. Keep
hair, clothing and gloves away from the
moving parts.
Keep the workspace clean, organized
and well illuminated in order to reduce
the risk of accidents.
The control and safety devices installed
in the machine must not be removed or
inhibited.
Do not cover the power tool during
use. To avoid the risk of electric tool
heating, always keep the ventilation
outlets clean and unobstructed to allow
air circulation.
2.5 - MAINTENANCE AND
CLEANING
Before cleaning, adjusting, repairing
and maintenance works, the power
cable must be unplugged.
Replace worn or damaged parts
immediately, so that the machine is
always in a safe operating condition.
Cleaning:
The machine must be carefully cleaned
after each use.
Do not use aggressive cleaning
products. These products may damage
plastics and metals, compromising the
safe operation of the machine.
Maintenace:
Only maintenance works described in
this instruction manual may be carried
out; all other works must be performed
by an official distributor.
Keep all nuts and screws well tightened
in order to ensure a safe operation.
or
people,
Use only VITO-approved tools for this
machine or technically identical parts.
Not doing so may result in personal
injuries or damages to the machine. In
case of doubt, you should contact an
official distributor.
2.6 - TECHNICAL ASSISTANCE
This machine must be repaired only by
the brand official technical service or
by qualified technicians and only with
original replacement parts.
3. ASSEMBLY
INSTRUCTIONS
3.1 WHEELS ASSEMBLY
Fixed wheels (4)
1. Place the wheel on the wheel support
shaft;
2. Insert the locking key into the shaft
bore;
3. Bend the ends of the cotter pin;
4. Fit the wheel cover;
Rotating wheels (2)
1. Insert the wheel fixing bolt into the
hole;
2. Place washer and locking nut on
securing bolt;
3. Tighten the nut to secure the wheel;
3.2 MONTAGEM DA CORRENTE
PARA DESCARGA
DE ELETRICIDADE (FIG. D)
During use of the vacuum cleaner,
particularly when dust is drawn in,
there is static electricity generation.
Therefore, always keep the discharge
current of static electricity, placed in
the base of the vacuum cleaner and in
contact with the floor.
1. Tighten the chain locking screw (1) on
the base of the vacuum cleaner;