Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING AND ADJUSTING THE
QUICK-ADJUST FRONT HANDLE
WARNING:
battery pack from the product when you
are assembling parts, making adjustments,
cleaning, or when the product is not in use.
1. Stop the motor and remove the
battery pack, if installed.
2. Loosen and remove the quick-
release lever and wing nut from the
front handle (Fig. 3a).
3. Push the front handle onto the shaft
within the mounting zone between
the threshold ring and the coupler
on the power-head shaft (Fig. 3b).
4. Insert the clamping block into the
handle slot (Fig. 3c).
5. Mount the quick-release lever and
tighten the wing nut. Make sure
that the front handle is positioned
upwards and points toward the top
of the rear handle (Fig. 3d).
6. Pull the quick-release lever up to
move/rotate the front handle to a
comfortable operating position
(Fig. 3e).
Always remove the
56-VOLT LITHIUM-ION POWER HEAD — PH1420/PH1420-FC
3a
Quick-release
Lever
Clamping Block
3b
Front Handle
3c
3d
Wing Nut
Front Handle
Wing Nut
Threshold Ring
Coupler
Clamping Block
Quick-release Lever
19
Publicidad
