Cramer 2400986 Manual De Instrucciones página 5

1 DESCRIPTION
1.1 PURPOSE
The machine is used to propel air out of a tube to move
unwanted materials such as leaves in the yard. This machine
also sucks in leaves and small twigs through a vacuum, and
shreds them into a bag.
1.2 OVERVIEW
Figure 1 - 13.
Tube
1
Trigger
2
Cruise control
3
Turbo button
4
Harness
5
Battery life indicator
6
Trigger handle
7
Connecting tube
8
Knob
9
10 Cord
11 Cord retainer
12 Tube
2 GENERAL SAFETY
WARNINGS
WARNING
Read all safety warnings, instructions, illustrations and
specifications provided with this machine. Failure to
follow all instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
3 INSTALLATION
3.1 UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
• If parts of the machine are damaged, do not use the
machine.
• If parts are missing, do not operate the machine.
• If parts are damaged or missing, contact the service
center.
English (Original Instructions)
13 Tube
14 Blower release button
15 Latch
16 Dust cover
17 Battery release button
Groove
a
Tab
b
Lock position
c
Upper possition
d
Chest strap
A
Hardness strap
B
Waist strap
C
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
WARNING
For your personal safety, do not insert battery before the
tool is assembled completely.
3.2 INSTALL THE TRIGGER HANDLE
Figure 2.
1. Slide trigger handle (7) on the connecting tube (8).
2. Move trigger handle to desired location before fully
tightening. Use supplied knob (9) to tighten trigger
handle to the connecting tube.
3. Place the cord (10) in the cord retainer (11).
3.3 INSTALL THE BLOWER TUBE
Figure 3 - 5.
1. Align either of the grooves (a) in tube (12) with the tabs
(b) on tube (8). Turn the tube (12) in the direction of the
arrow until both of the tabs slide into the lock positions
(c).
2. Connect the tube (13) to tube (12). For shorter tube
application, turn rear tube counterclockwise and move
tube to upper position (d).
3.4 ASSEMBLE THE TUBE ASSEMBLY
Figure 6.
The tube assembly can be disconnected from the backpack
assembly.
1. Press the blower release button (14) and pull up to
disconnect the tube assembly from the backpack
assembly.
3.5 INSTALL THE BATTERY PACK
Figure 7.
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read and understand the instructions in the battery and
charger manual.
1. Unlock the latches (15) on both sides to release the dust
cover.
5
EN