Cramer 2400986 Manual De Instrucciones página 6

EN
2. Remove the dust cover (16) to expose the battery
compartment.
3. Align the battery pack with the cavity in the backpack
housing.
4. Insert the battery pack into the backpack housing.
5. Push the battery pack into the backpack until it locks into
place. You will hear a click once it is locked into place.
6. Do not use force when inserting the battery pack. It
should slide into place and click.
Please keep the dust cover installed to prevent entry of dust
or water.
The blower can hold two batteries, but only one of the
batteries works during operation.
3.6 REMOVE THE BATTERY PACK
Figure 7
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
3.7 ADJUST THE HARNESS
Figure 8-12.
1. Fit the backpack on your back.
2. Pull the ends of the straps down to tighten the harness.
3. Connect the horizontal chest strap.
4. Pull the end of the chest strap to tighten.
5. Lift the tabs of the adjusters to loosen the straps.
6. Lock the quick-release fastener by pushing it together.
7. Squeeze the hooks to open the quick-release fastener.
Install the back pad against your back tightly and safely.
3.8 REMOVE THE HARNESS
1. Open the quick-release fasteners on the chest strap.
2. Loosen the harness straps by lifting the sliding adjusters
and then take off the machine.
In the event of imminent danger, quickly remove the
machine. Release the chest strap before you put the machine
on the ground.
English (Original Instructions)
NOTE
NOTE
NOTE
WARNING
4 OPERATION
WARNING
Make sure the blower tube is in position before operation.
4.1 START THE MACHINE
Figure 13.
1. Insert two batteries.
2. Pull the trigger to start the machine.
3. Pull the trigger fully to increase the speed.
4. Release the trigger to decrease the speed.
4.2 STOP THE MACHINE
1. Release the trigger to stop the machine.
Wait until the motor stops after you stop the machine.
4.3 CRUISE CONTROL LEVER
Figure 13.
1. Pull the cruise control lever to the "Rabbit" mark side to
increase the speed of the machine.
4.4 TURBO BUTTON
1. Push the turbo button (1)once, the machine is at the
highest speed.
2. Push the turbo button again, the machine is at the normal
speed.
Using the turbo button drains the battery the fastest. Only
use the turbo button when needed.
4.5 OPERATION TIPS
• Blow around the outer edge of the unwanted materials to
prevent the unwanted materials from scattering.
• Use rakes and brooms to clear the unwanted material
before you blow.
• Make the surfaces wet before you clear the unwanted
material in dusty conditions.
• Look out for children, pets, open windows, and cleaned
cars during operation.
• Clean the machine.
• Discard the unwanted material when you complete work.
6
NOTE
NOTE