Publicidad
Preparation
• The air compressor delivers energy to pneumatic tools as versatile as power tools, therefore, it can be used to drill,
screw, nail, rivet, staple, chisel, polish, torch, clean, paint, etc.
• The compressor is totally automatic, controlled with a pressurestat that stops the motor when the tank pressure reaches
the maximum level and start back when the level is lower to 87 PSI
• The compressor shall be connected into power supply protected with an adequate thermos-differential switch
(thermal-magnetic).
Assembly
• Screw the air filter (A) aside de carter as indicated in the
image.
Oil
CAUTION
• Replace the transport cap (B) with the
work cap (B
1
) included.
• Check the oil verifying spyhole (C). If oil level is not in
the middle point (red circle), remove the tank cap (B
and fill up the deposit with compressor lubricating oil
SAE-10W30 up to the indicated level.
• Check the oil level when starting the
CAUTION
job.
• Leave the compressor running a few minutes with the air
valve fully open to allow the correct distribution of the
lubricant.
1
)
A
B
B
1
C
ENGLISH
7
Publicidad
