Publicidad
Idiomas disponibles
Idiomas disponibles
Do not start the vehicle while the battery charging cables are connected and
NOTICE
the generator is running. The vehicle or the generator may be damaged.
An overloaded DC circuit will fuse the DC fuse, if this happens, replace fuse.
An overloaded DC, excessive current draw by the battery, or a wiring problem
will trip the DC circuit protector (Push button extends out). If this happens, wait a few minutes
before pushing in the circuit protector to resume operation. If the circuit
protector continues to go OFF. discontinue changing and see your authorized generator dealer.
Disconnecting the battery cables:
①. Stop the engine,
②. Disconnect the negative (-) battery cable from the generator negative (-)terminal.
③. Disconnect the other end of the negative (-) battery cable from the battery negative (-)terminal.
④. Disconnect the positive(+) battery cable from the generator positive (+)terminal,
⑤. Disconnect the other end of the positive(+)battery cable to the battery positive(+) terminal.
⑥. Connect the vehicle ground cable Io battery negative (-) terminal.
⑦. Reconnect the vehicle grounded battery cable.
6) High Altitude Operation
At high altitude, the standard carburetor air-fuel mixture will be excessively rich.
Performance will decrease, and fuel -consumption will increase.
High altitude performance can be improved by installing a smaller diameter main fuel
jet in the carburetor and readjusting the pilot screw, If you always operate the engine
at attitudes higher than 5000 feel (1500 meters) above sea level, have an authorized
generator dealer perform this carburetor modification.
Even with suitable carburetor jetting, engine horsepower will decrease approximately
3.5% for each 1000 foot (300 meter) increase in altitude. The effect of altitude on
horsepower will be greater than this if no carburetor modification is made.
If a engine jetted for high altitude is used at a lower altitude, the lean air fuel
NOTICE
mixture will reduce performance and may overheat and seriously damage the
engine.
5. PRE-OPERATION CHECK
1) Engine oil
Engine oil is a major factor affecting engine performance' and service life non
detergent and 2-stroke engine oils will damage The engine and are not
NOTICE
recommended
10
Publicidad
