switch will remain in the ON position). The oil alert system shuts down the engine and
the engine will not start. If this occurs, first check engine oil.
4. GENERATOR USE
1) Connections to a Building'sElectrical System
Connectionsfor standby power to a building'selectrical system must be made by a
qualified electrician. The connection must isolate the generator power from utility powerand must
com ply with all applicable laws and electrical codes.
Improperconnections to a building's electrical system, can allow electrical
current from the generator to feedback into the utility lines, Such feedback
△
!
WARNING
may electrocute utility company workers or others who contact the lines
during a power outage. Consult the utility company or a qualified
electrician.
Improper connections to a building's electrical system can allow electrical
current from the utility company to feedback into the generator. When
△
!
CAUTION
utility power is restored, the generator may explode, burn, or cause fires in
the building's electrical system.
2) Ground System
To prevent electrical shock from foully appliances, the generator should be grounded.Connect a
length of heavy wire between the ground terminal and the ground source.The generators have a
system ground that connects generator frame components to the ground terminals, in the AC output
receptacles. The system ground is not connected to the AC neutral wire. If the generates is testedby
a receptacle tester. It will not showthe same ground circuit condition as tor a home receptacle.
Special Requirements
There may be Federal or State Occupational Safety and Health Administration (OSHA) regulations,
local codes, or ordinances that apply to the intended use of the generator Please consult a qualified
electrician, electrical inspector, or the local agency having jurisdiction.
- In some areas, generators are required to be registered with local utility companies.
- If the generator is used at a construction site, there may be additional regulations which must be
observed
7