Publicidad
FIG. 3
3) Glue two Dowels (P) in each end of the Front Apron (G) and the Side Aprons (H). Lay the aprons on
the bottom of the Seat (J) in their approximate positions. See FIGURE 3.
Note: The Front Apron (G) is square on both ends. The Side Aprons (H) are square on the front end
and angled on the back end to fit against the back legs.
FIG. 4
4) Glue the two Front Stretchers (K) into the round holes in the side of the Right Front Leg (M). Glue
the Front Apron (G) into the two dowel holes in the same side of the leg. Now glue the front stretch-
ers and front apron to the Left Front Leg (L). See FIGURE 4. Insert a #8 x 1¾" Pan Head Screw (Q)
through each front leg into the front apron and fasten securely.
FIG. 5
5) Glue the Side Aprons (H) to the back leg assembly. The square end of the aprons must be toward
the front and the angled end must match the angle on the Back Leg (E).
Glue the Upper Side Stretchers (N) and the Lower Side Stretchers (U) into the back leg assembly.
6) Glue the front leg assembly onto the Side Aprons (H) and Side Stretchers (N & D). See FIGURE 5.
P
P
H
P
dowel holes
L
N
H
G
J
L
K
K
Q
U
P
P
Square end
H
Angled end
P
M
G
Q
E
side stretcher
holes
177W/178W — PAGE 5
Publicidad
