Publicidad
280Wb Lakeview Storage Chest — Parts List
Before beginning assembly, check that the quantities of the parts received match those on the parts list below.
Ab — Top Assembly — Qty. 1
C — Side — Qty. 2
Bb — Front Panel — Qty. 1
I — Cam Pin — Qty. 10
SPECIAL INSTRUCTIONS
I f a top or panel should become cupped, do not be alarmed. The panel was fl at when it was
manufactured. It is a natural characteristic of wood in an unfi nished state to cup
from uneven moisture conditions. The fi gure at the right shows an exaggerated
view of what could happen. This only means that the convex side has
absorbed moisture, or the concave side has dried out.
Usually a cupped panel will equalize and straighten out if both sides are
exposed to similar conditions for a day or so.
280Wb — Page 2 — 04/08
J — Cam Lock — Qty. 10
Db — Back Assembly — Qty. 1
DO NOT FINISH CEDAR SIDE OF
BOTTOM IF CEDAR AROMA IS
DESIRED.
NE FINISSEZ PAS LE CÔTÉ CÈDRE DU FOND SI
VOUS DÉSIREZ AVOIR L'ARÔME DU CÈDRE.
SI DESEA EL AROMA A CEDRO, NO APLIQUE
ACABADO AL LADO DE CEDRO DEL PANEL
INFERIOR.
E — Bottom — Qty. 1
Fb — Base Assembly — Qty. 1
G — Top Support — Qty. 2 (attached)
H — Bottom Support — Qty. 2 (attached)
K — #8x1¼" Black Screw— Qty. 6 (inserted)
L — #8x1-5/8" Black Screw— Qty. 6 (inserted)
N — Hinge — Qty. 2 (attached)
P — Bumper — Qty. 2 (attached)
MM — #6 x 3/4" Brass Flat
Head Screw — Qty. 8
+ 6 inserted
O — Lid Support — Qty. 1
Publicidad
