Publicidad
STEP 3
3) Attach the Front Panel (B) to the Sides (C) with the Cam Pins (I) that you've already put in place.
Insert two Cam Locks (J) in the upper two holes on each Side (C). Attach the Base Assembly
(Fb) in the bottom holes on each Side (C) with two Cam Locks (J). See Figure 3.
STEP 4
Fig. 4
4) Spread a thin layer of glue on the top edge of both bottom supports that are on the inside of your
chest assembly. Tilt the Bottom (E) up and slide it on to the bottom supports. Press firmly into
place. The cedar side should face up if you desire the cedar aroma.
NOTE: One side of the Bottom (E) is cedar. When finishing the chest, DO NOT seal the
cedar surface of the bottom if you would like the cedar aroma. To cover up the cedar
aroma, completely seal all surfaces of the bottom.
Db
J
C
B
Fig. 3
E
C
J
Fb
I
X 6
280Wb — Page 4 — 04/08
Publicidad
