Publicidad
Idiomas disponibles
Idiomas disponibles
Model 1968
TROUBLESHOOTING
Visit BLACKSTONEPRODUCTS.COM/SUPPORT for additional
troubleshooting.
Section 01
PIEZO-ELECTRIC IGNITION
SYMPTOMS
01. Burner will not ignite with piezo ignition system
If ignition does not occur in 5 seconds, turn the burner controls off, wait 5
minutes and repeat the lighting procedure.
If this does not work, to determine the cause, please try to ignite your appli-
ance with a match. (Please reference the Match Lighting Instructions in the
Cleaning the Burner Assembly section of the Care & Maintenance chapter.)
If you CAN ignite your appliance with a match
POSSIBLE CAUSES
01. Ignitor wire misaligned.
02. Damage to the ignition system.
If you CAN NOT ignite your appliance with a match
POSSIBLE CAUSES
03. Burner tubes are not
receiving propane.
SOLUTION
Ensure that the ignition needle is posi-
tioned 1/8" to 1/4" away from the burner
tube, positioned above a burner hole.
Contact customer service for replace-
ment parts.
SOLUTION
Please reference the Gas Flow section of
the Troubleshooting Chapter.
Troubleshooting
| Owner's Manual
3-7mm
Ensure that the ignition needle is
positioned 3-7mm away from the
burner tube, positioned above a
burner hole.
11
Publicidad
