Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
How to Install In Pre-Existing Wall Sleeve
1. Identify the wall-sleeve brand for your installation, from the chart below.
NOTE: All wall sleeves used to mount the new air conditioner must
be in sound structural condition and have a rear grille that securely
attaches to sleeve, or rear flange that serves as a stop for the air
conditioner.
IMPORTANT:
have a rearward slope as shown.
2. Remove old air conditioner from wall sleeve and prepare wall sleeve as follows:
through sleeve, into wall, if needed.
3.
left side of the wall sleeve (see approximate hole location dimensions in the
of the supplied green striped ground wire to the inside of the wall sleeve. The
toothed washer must be between the eyelet of the wire and the wall sleeve. BE
CAREFUL TO NOT OVERTIGHTEN THE SCREW. Pull loose end of ground
wire out front of sleeve, and temporarily bend it down and around lower edge of
sleeve. This ground wire will later be attached to frame of air conditioner once it is installed.
4. Prepare the wall sleeve for installation of the new unit per the following brand instructions.
1
2
3
4
5
6
7
8
9
5. Identify your wall sleeve type and follow the instructions for that type in the following pages.
10
Wall Sleeve Dimensions (inches)
White-Westinghouse
Frigidaire
Carrier (52F Series)
GE/Hotpoint
Whirlpool
Fedders/Emerson
Sears/Kenmore
Carrier (51S Series)
Emerson/Fedders
Friedrich
Emerson
Fedders
Fedders or Friedrich
Sears or Carrier (51S Series)
Whirlpool
Whirlpool
Width
Height
26
27
27
REAR
15" Deep
23" Deep
22" Deep
Depth
15
3
to
Wall Sleeve
FRONT
UNIT LEVEL
. Drive more nails or screws
3
Max.
1
1/8
Hole
49-5000712 Rev. 1
Publicidad
