Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
Fedders (19-3/4" Deep)
4
1. Remove existing rear grille as shown on page 9
of this manual and replace with provided louvered
rear panel.
NOTE: You may need to drill holes in flange of
existing sleeve to match new rear grille.
2.
blocks, one on each side wall. Place in center of
side wall with the tapered end facing the opening.
3. Cut (2) 17" tapered spacer blocks as shown below
into two pieces.
3
/
Tapered Spacer Block
4
Cut Here
4. The 4" section is placed in front of the rib on base
with the tapered end facing the back of the sleeve.
The remaining portion will be placed behind the rib
again sloping toward
the rear of the sleeve. This helps induce a
rearward slope on the unit.
5.
the top of the sleeve. Remove the backing paper
and press into position.
6.
sides of the sleeve.
7.
them to the vertical sections of the rear grille.
8. Gently slide unit into sleeve.
9. Before sliding all-the-way back, remove the second
screw from front on left side of unit.
10. Remove the plastic washer from the screw.
11. Screw and attach the other end of the ground wire
to the unit. Make sure that the toothed washer is
against the cabinet.
12. Slide the unit completely to the rear to ensure a
good seal, making sure the ground wire does not
become tangled.
13. If you have difficulty with mounting the grill to the
sleeve, follow the instructions for direct mounting
on page 15.
14. Seal and frame the unit as described on page 16.
12
4
8
8
3
3
17
1
4
Protection Paper
Backing
Fedders or Friedrich (16-3/4" Deep)
4
3
1. Remove existing rear grille as shown on page 9
of this manual and replace with provided louvered
rear panel.
NOTE: You may need to drill holes in flange of
existing sleeve to match new rear grille.
2.
blocks, one on each side wall. Place in center of
side wall with the tapered end facing the opening.
3. Cut (2) 17" tapered spacer blocks as shown below
into three pieces.
17
3
/
Tapered Spacer Block
4
Cut Here
12-1/2
4.
base with the tapered end facing the back of the
placed behind the rib again sloping toward the rear
of the sleeve. This helps induce a rearward slope
on the unit.
5.
the top of the sleeve. Remove the backing paper
and press into position.
6.
sides of the sleeve.
7.
them to the vertical sections of the rear grille.
8. Gently slide unit into sleeve.
9. Before sliding all-the-way back, remove the second
screw from front on left side of unit.
10. Remove the plastic washer from the screw.
11. Screw and attach the other end of the ground wire
to the unit. Make sure that the toothed washer is
against the cabinet.
12. Slide the unit completely to the rear to ensure a
good seal, making sure the ground wire does not
become tangled.
13. If you have difficulty with mounting the grill to the
sleeve, follow the instructions for direct mounting
on page 15.
14. Seal and frame the unit as described on page 16.
4
8
8
3
1
2-1/2
Protection Paper
Backing
49-5000712 Rev. 1
Publicidad
