Zeegma Zonder Robo Next Manual De Usuario página 11

8. How to store:
•
If you do not use the vacuum cleaner for a long time, fully charge it before storing.
Charge the device every 3 months to prevent extensive deterioration of battery life.
PROBLEM POTENTIAL CAUSE
The vacuum cleaner No connection with the
does not charge. docking station.
The battery does not charge.
The vacuum cleaner The vacuum cleaner wraps in
has difficulties in elements of the room (cables,
vacuuming. drapes, etc.).
The vacuum cleaner Low battery.
returns to the
docking station
End of work time.
automatically.
The vacuum cleaner Vacuum cleaner is off
does not activate
Low battery
during scheduled
vacuuming.
Dustbin is clogged or other
elements are obstructed.
Remote control does Batteries in remote control
not work are flat.
The vacuum cleaner is off or
battery is low.
Infrared signal is not received
by the device.
9. How to prepare rooms for vacuuming
4.
Remove cables and other items which may get tangled in the vacuum cleaner from the
floor (fig. 16).
5.
The vacuum cleaner is intended to clean floors and thin short-hair carpets. Do not use
the cleaner on long-hair carpets (fig. 17).
6.
Position the furniture in a way that the vacuum cleaner cannot get stuck (fig. 18).
7.
Remove all obstacles from narrow areas (fig. 19).
The pictures are for reference only. The real design of the products
Make sure charging ports of the vacuum cleaner and docking
station are properly connected. Try to place the product on
the docking station manually.
Make sure the docking station is plugged in. If you have not
used the vacuum cleaner for a long time and battery does
not charge, place the cleaner on the docking station and
charge for 3 minutes, then stop charging. Repeat 3 times
and then start charging the vacuum cleaner normally.
The vacuum cleaner tries to steer clear of obstacles. If it
is impossible, remove obstacles before you start another
vacuuming.
This operation is normal.
This operation is normal.
Switch the vacuum cleaner on.
Charge the battery.
Switch the device off and clean the dustbin and filters.
Replace batteries in the remote control.
Switch the device on and/or charge the battery.
Clean the infrared sensor on the device and remote control.
Check the space between the remote control and device for
any obstacles blocking the signal and other items emitting
infrared signal (e.g. TV remote control).
may differ from the pictures presented.
SOLUTION
EN