Zeegma Zonder Robo Next Manual De Usuario página 9

Two ways of charging (see fig. 10):
1.
Place the product on the docking station.
2.
For charging, use the power supply (when charging, the signaling light flashes, when
charging is over, it turns green
•
When the battery goes flat during cleaning, the product automatically switches into
charging mode and goes to the docking station to initiate charging.
•
Activate the charging mode with the return-to-docking-station key on the remote
control or via the application.
Charging notes:
1.
The docking station must not be used in a direct sunlight.
2.
Before you start using the product, remember to fully charge it. Charging takes 4 hours.
3.
When charging, do not fix the water tank in the product to make sure the charging is safe.
4.
The device contains batteries that should only be replaced by a qualified person. In case
of problems with the battery, contact an authorized service center.
Description of vacuuming modes and functions:
1.
1. Automatic vacuuming: activate the main switch of the product. When the control
light goes on, the product is active. Press start/pause key on the cleaner or remote
control and the cleaner will start vacuuming automatically.
2.
Spot vacuuming: press the spot vacuuming on the remote control to start cleaning.
3.
Edge vacuuming: press the edge vacuuming key on the remote control to start cleaning.
4.
Manual control: use remote control keys to choose direction of cleaner's movements
(forward, backward, left and right).
5.
Suction power adjustment" in automatic vacuuming mode, press suction power
adjustment key on the remote control or in the application to adjust the suction power.
Suction power adjustment works only in the automatic vacuuming mode.
Options:
•
Pause: when the cleaner operates, press start/pause key on the cleaner, remote control
or in the application to stop its operation.
•
„Wake up": The cleaner will go to sleep if it remains inactive for 10 minutes. To „wake
it up", press any key on the cleaner, remote control or in the application.
•
Deactivation: to switch the cleaner off, press start/pause key and hold for a couple of
seconds or deactivate the main switch on the product.
•
When the work is done, direct the vacuum cleaner into the docking station to charge it.
EN