Publicidad
Idiomas disponibles
Idiomas disponibles
Step 6
wnrod so the hole in the downrod aligns with the hole in the
the motor. Insert safety bolt (S8) through coupling and downrod
ut. Tighten firmly. Tighten set screw "A" against downrod. Place
(5) over downrod assembly until it covers flange. Place canopy
wnrod (2). Replace hanging ball, insert hanging pin through
d tighten set screw "C" in hanging ball into downrod.
e cover will not work with supplied 2 1/2 inch downrod. Flange cover is
will not affect the operation of the fan.
Threaded
Set Screw Hole
Ground
g
Wire
Ball
g
Screw
Safety Bolt & Nut
ING:
to completely tighten downrod as described in steps 5 & 6 above could
n the fan loosening and possibly falling.
All manuals and user guides at all-guides.com
7
For added security, attach safety cable from fan unit to "J" hook (S10) in
outlet box. Secure by looping zip tie (S11) through safety cable and "J"
hook. Tighten zip tie securely. Lift fan onto the mounting bracket (1).
Turn housing until hanging ball seats itself into ball socket (listen for click).
Set Screw (C)
Downrod (2)
Canopy (3)
Flange Cover (4)
Set Screw (A)
Motor Housing (7)
OUTLET BOX
Green Ground Wire
NOTE: Parts furnished will allow
"J" Hook (S10)
you to install your fan at up to a 35°
Zip Tie (S11)
angle. Angles greater than 35° will
require a 45° angle adapter (see
Safety Cable
dealer). NOTE: J Hook installation
is a Canadian requirement only.
WARNING: To reduce the risk of fire, electric shock or personal injury, mount
so outlet box marked "acceptable for fan support" and use mounting screws
provided with the outlet box. Most outlet boxes commonly used for the support
of lighting fixtures are not acceptable for fan support and may need to be replaced.
Consult a qualified electrician if in doubt.
Step 7
Support Beam
"J" Hook (S10)
Outlet Box (A)
Ceiling
Mounting Bracket (1)
Publicidad
