Before Connecting The Appliance - Mx Onda MX-HC2600 Manual De Instrucciones

BEFORE CONNECTING THE APPLIANCE

Read these instructions and save them for later use carefully.
Check that the voltage of your outlet is 220-240 V and is
provided grounding.
Before using the oven for the first time, you should wash the
accessories included (tray, grill, etc.) with soapy water or in the
dishwasher.
In order to remove traces of oil from the manufacture must put
the oven in operation for 15 minutes in the oven mode (heat at
the top and bottom) and the maximum temperature.
The first few times you use the oven may peel off some smell,
this is normal and not a malfunction.
The electrical safety of this appliance is only guaranteed if it is
connected to an outlet with a efficient earth, as envisaged
safety regulations in force.
The manufacturer is not liable for damage caused by the lack
of grounding in the installation. If in doubt, consult a
professional.
If you need to use an extension cord, use only an extension
cord that is in good condition with grounded plug and is
suitable for the power of the appliance.
Do not leave the power cord below the oven, which comes into
contact with hot surfaces and do not fit in the door hinges or
the area because you risk damaging or cutting the insulating
sheath of the cable network.
After removing the packaging, check that the appliance is not
damaged. If in doubt do not use it and contact the technical
support staff.
Keep out of reach of children packaging materials (bags,
polystyrene, etc.), as they are a potential source of danger.
The manufacturer declines any liability for damages resulting
from improper, incorrect or careless use of the appliance.
3