Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING! A falling lift table can cause severe
personal injury or death. Never go under the
platform until the load is removed and the
scissors mechanism is secured in the raised
position with the safety bars. The safety
bars are designed for use only when the lift
is unloaded. Never place any load on the
platform with the safety bars engaged. Severe
personal injury, death and property damage
could result.
WARNING! Do not put foot or hand in scissor lift
mechanism.
WARNING! The table uses a power supply of 115
Volts AC. This voltage can cause serious injury
or death. Do not work with electrical parts
unless you are a qualified electrician.
WARNING! Remove load and engage
safety bars before performing inspection
or maintenance work. (See Figure 10)
Figure 10
Safety Bar
CAUTION! Safety bar automatically stops table
movement when in operation.
MAINTENANCE SCHEDULE
DAILY:
• Before use, visually inspect the table for worn,
damaged or broken components. If any of these
conditions exist, do not use the table and contact a
qualified service person.
• Raise the platform and visually inspect the hydraulic
components (i.e. pump, hoses, fitting and cylinders)
for oil leakage.
PAGE 4 OF 17
OPERATION CONTINUED
ADDING OIL
If the platform won't raise to the rated height, hydraulic
fluid may need to be added. Hydraulic fluid must be
ISO VG32 or equivalent with a viscosity of 32cSt at 104°F.
Mixing of different fluids is prohibited.
LUBRICATION
Periodically lubricate all grease fittings according to
the required maintenance schedule using multipurpose
lubricating grease ZG2# or 3#.
MAINTENANCE
• If oil leakage exists, do not use the table and
• Raise the table and disengage the maintenance
1 MONTH:
• Grease joints and bearings.
• Visually inspect the leg rollers, center pivot bushings,
• Check hydraulic system for leakage and full range
NOTE: When platform is at minimum height,
the hydraulic oil level is about two-thirds of the
height of oil tank.
NOTE: Waste oil must be disposed of in
an environmentally friendly way and in
accordance with regulatory authorities.
contact a qualified service person.
bars by returning them to their stored position.
WARNING! Do not attempt to repair table
unless you are trained and authorized. Before
servicing table, remove any load and use the
safety bars to properly secure lift.
WARNING! Lift may not be altered in any
way without written permission from the
manufacturer.
pins, cylinder clevis pins/bushings and leg hinge
pins/bushings for signs of wear.
of motion.
0323 IH-10646
Publicidad
