Worldcast Systems APT Codec Frame Guía Rápida página 6

English version
6. Click on "ok" and your stream will then appear in the Streams Table. Add additional streams if
required.
Figure 6: Shows the stream table with a Receive stream and a Transmit stream configured
7. Click on "Create" on the bottom of the toolbar to create the configuration.
8. To apply this configuration click on "Apply". This will immediately reconfigure the codec to these
settings.
5. Connecting using an existing Configuration
1. Quick Connection should be used
once configurations have been
setup already. A quick connection
would then be used to apply this
configuration.
2. Select the desired connection from
the list and press "Apply".

Once both units are configured, display the Status pages for a quick view of the unit status, alarms,
relay/opto and performances (see screenshot on the 1
6
For more details about the product please refer to the user manual.
Figure 7: Shows the quick connection profile selection
st
page of this notice).