Publicidad
Idiomas disponibles
Idiomas disponibles
Front Panel Components
AoIP Codec front panel
The rear panel module terminates all audio signals to a D37way connector. With the XLR breakout
cable provided you can quickly connect your audio inputs and outputs with standard XLR cables. For
more information refer to the AoIP Codec Module manual.
01
Indicates the operational mode configured by
software:
Encoder: Encoder Mode – Transmit only
Decoder: Decoder Mode – Receive only
Both: Duplex Codec Transmit & Receive
02
3.5 mm Monitor Output:
Drives a headphone with fixed volume or can be
used for active monitors
03
Monitor Source Selector
Selects a pair of signals, either A&B or C&D. Signal
source can be either Input/Output A/B C/D or Input
A/B Output C/D depending on the selected mode
04
Module Status Indicator – Tri-Color
- Applying Power
- Rebooting from GUI
- On firmware update
- Any failure on Card
- I/O interface missing
- Off Bus for central transport card
- Normal operation
05
IP Address Reset Button (recessed)
Pressing this button for more than 5sec. sets the
AoIP card to default IP addresses (status LED:
orange)
06
Signal Level Light Pipes
Indicate the presence of audio signals for channel
A/B/C/D (Red = 0 dBFs)
07
RTP Traffic Indication – Streaming LEDs
Other than the LEDs on the network interface (ETH)
these LEDs indicate only RTP traffic from and to the
AoIP card.
08
Network Interfaces
09
Two network interfaces provided: ETH0 and ETH1.
Both operate independently and must be configured
for different sub-networks. Both are operational for
audio streaming and WEB browser access.
English version
static orange
static Orange
flashing Orange
static Red
static Red
flashing Green
static Green
7
Publicidad
