Publicidad
Idiomas disponibles
Idiomas disponibles
Hints for reception:-
Extend the tele-scopic antenna for best reception.
FM scan setting
After auto tuning if too many unwanted weak radio stations are received, you can select strong stations only
by filtering out the weaker signals.
1. In FM mode, press Menu button (2.) and the display will show <Scan setting>, then press Enter button
(8.).
2. Press Tune + / - (4) button to select "Strong station only". Then press Okay/Enter button (8.) to confirm
the setting.
3. Perform the auto tuning operation again as above.
FM Mono & FM-stereo reception
By default, all stereo stations are reproduced in stereo. For weak signal, this may result in a poor signal-to-
noise.
To play weak signal in mono mode, follow the below steps to switch between stereo and mono setting.
1. Press the Menu button (2.) and press Tune + / - (4) button to select <Audio setting>. Then press Enter
button (8.) to confirm.
2. Press Tune + / - (4) button to select < Forced mono >. Then press Enter button (8.) to confirm the setting.
3. When you wish to switch to stereo signals, follow the same procedure but to select < Stereo allowed >.
Audio setting:
1. Press the Menu button (2) then press Tune + / - (4) button to select 'Audio setting' then press Confirm Enter
button (8.) to confirm.
2. Press Tune +/- button (4) to select 'Force mono" then press Confirm Enter button (8.) to confirm.
Hints for best reception: -
FM: the receiver has a rod antenna (17.) at the rear cabinet. This antenna should be totally unraveled and
extended for the best reception.
Radio data system (RDS)
This is the feature which displays the information released from the radio broadcast and will showed on the
LCD display step by step as below by pressing the Info button (9.) continuously.
Radio text→ program type→ frequency→ mono/stereo → time → date
Preset memory stations
You can store 10 FM stations in the memory
1. Turn to the desired radio station by "manual" or "auto" tuning method.
2. Press and hold the Preset button on the remote for 2-3 seconds, the display will show "Preset Store" <1:
(Empty) >.
3. Then press Tune + / - button on the unit or remote to select the desired Preset Store number.
4. Press Enter button to store the location (1-10). Display will show Preset 'X' stored
Remarks:
1. If the preset station is already stored, the display will show the frequency next to the preset station, eg:<1:
94.50MHz >.
2. The preset station will be overwrite when new radio station is being stored.
3. For present station number 1, 2, 3, 4 they can be stored directly by pressing and hold the button (12.) or
(13.) or (14.) or (15) on the main unit after turned to the desired radio station.
Recall preset memory:
1. Press the Preset buttons on the remote control to recall the preset station directly.
2. For preset station nr. 1 button (12) / nr. 2 (13.) / nr. 3 (14.) / nr. 4 (15.) on the main unit directly to recall
these three preset stations. Menu button (2) then press Tune + / - (4) button to select "Preset Recall.
3. Display will show the preset station frequency and preset store number (P1, P2, P3... etc).
8
Publicidad
