Publicidad
Idiomas disponibles
Idiomas disponibles
The Sealing function:
1. Cut bag material to appropriate size you desired, Be sure to cut
straight and flat.
2. Open the lid,place one end of bag on the sealing wire⑪.Be sure
to stretch the end of bag flat.
3. Press the lid down firmly on both sides at the same time until you
hear a click, which indicates the vacuum sealer is completely locked.
4. Connect the power supply, press the "Seal" button ③ to initiate the
sealing function,at the same time the green indicator is light up, after
11 seconds, It stops automatically when finished sealing,the green
indicator is off.
5. At the same time, Press the two release button ④ to open the lid,
take out the sealed bag.
Notes: *Allow the vacuum sealer to cool down for 30seconds after
each time it is used.
Removing Air from a Bag
Avoid wrinkles when inserting the bag into the Vacuum Channel
Wrinkles in seal may cause leakage and allow air to return into bag.
To eliminate any wrinkles while inserting bag, gently slide bag curl
down into the Vacuum Channel, and hold bag with two hands gently
stretching bag flat until vacuum pump begins. If you find wrinkles
after sealing bag, simply cut bag open and vacuum seal again.
If motor runs for more than 30 seconds without stopping, consider the
following:
If you are vacuum sealing with a bag, make sure one end of the bag
is properly sealed. If vacuum sealing with an accessory, check
Handheld Sealer connections to ensure a tight fit.
05
Publicidad
