Bromic Heating 3400W Manual De Instrucciones página 6

9. Remove the lid of the terminal box by removing
the 4x M4x8mm screws and set aside for re-
assembly.
1000mm (39.3") - 3400W
10. Cut down the heater cable no shorter than
800mm (31.5") - 2300W
1000mm (39.3") for the 3400W unit, or 800mm
(31.5") for the 2300W unit measured from the
cable gland.
11. Feed the heater cable through the lower M16
cable gland located on the terminal box. Ensure a
that the cable gland is tightened.
12. Feed the mains (and control cables if
applicable) through the terminal box cut-out in
the heater box.
Refer to the wiring diagram diagrams on the next
page
For installs using a Bromic Dimmer (sold separately) OR
On/Off Controller (sold separately), please refer to the electrical diagram on page 11.
For installs using a manual wall switch (not supplied), please refer to the electrical diagram
on page 12.
Comprehensive electrical diagrams can be found on page 14.
bromic.com
6