Publicidad
10. CRADLE MOUNTING INSTRUCTIONS
10.2 Cradle Mount Combo Hanger Installation
Suitable for pipes up to 1 3/4" (45 mm) in diameter, and for trusses or channel up to 2 3/4" (70 mm) wide.
1
Place the power supply on a flat work surface as shown, with the
"FLUENCE" name upside down. Place one bracket behind the power
supply end plate and align the screw holes.
Install a screw and washer in each hole and tighten. Ensure the washer
2
is installed in the correct direction as shown for proper fit and function.
Do not overtighten.
3
Repeat steps 1 and 2 at the opposite end.
4
Take (2) mounting hangers. Place both hangers over the support
structure as shown.
Turn the power supply over. Firmly hold the power supply with up to
5
the hangers, in line with the support structure, as shown.
Hook each hanger end onto the upper loops at each corner of the
6
power supply. Continue to firmly hold the power supply until all 4
loops are securely hooked.
Hold a VYPR 3x fixture up to one side of the brackets, and slide it onto
7
the brackets. Align the fixture evenly and guide the brackets between
and through the cooling fins. Rest the VYPR 3x fixture on the brackets.
Ensure that the brackets are all the way through, and the VYPR 3x
fixture top frame rests securely on the brackets as shown.
Repeat Step 7 to install the second fixture on the opposite side.
8
5a
7a
5b
7b
1
3
6a
8
2
4
6b
19
Publicidad
