Kreg Precision Router Lift PRS5000 Manual Del Propietário página 5

Position the Clamp Blocks
Install the Router Motor
Setup
The Kreg Precision Router Lift can be installed in a router table with a
ATTENTION
straight-sided opening equipped with Kreg Precision Router Table Insert Plate Levelers or in a
rabbeted opening sized to support the edges of the router lift plate.
STEP 1: With the lift right side up, insert the crank shaft into the LOCK bushing and
turn it counterclockwise to unlock the carriage. Insert the crank shaft into the bushing
at the center of the micro-adjustment dial. Raise the motor carriage until it contacts
the O-rings at the tops of the carriage shafts.
ATTENTION The carriage lock rotates approximately ½ turn.
STEP 2: Turn the lift upside down. Use the hex wrench to remove the shoulder bolts
securing the clamp blocks to the carriage. Referring to Table 3, reinstall the clamp
blocks in the numbered-hole pattern indicated for your router.
ATTENTION If your router is not listed, measure the diameter of the motor and install
the clamp blocks in the number pattern that matches that diameter.
TABLE 3
Hole Pattern Router
1 Porter-Cable 7518
2 Milwaukee 5626
3 Hitachi M12VC, KM12VC
4 Milwaukee 5615, 5616, 5619
Porter-Cable 690, 890
Craftsman 17543, 17540, 28190
5
Bosch 1617, 1618
DeWalt 610, 616, 618
6 Ridgid R29302
7 Felisatti RF62
8 Makita 1101
STEP 1: Install the insert ring with the 2
(See Insert rings in the USING THE LIFT section.)
STEP 2: Place the lift upside down on scrapwood blocks tall enough to allow the
router collet to extend through the insert ring. Use the crank to loosen the motor-clamp
screw and slightly spread the carriage. Slide the router motor into the carriage until it
rests on the insert ring. Orient the motor to provide convenient access to the controls
when the lift is installed in the router table with the Kreg logo on the lift plate toward
the front. Raise the motor ⁄
1
16
STEP 3: Turn the lift right side up and install it in your router table.
Clamp Block Locations
" opening in the router plate.
⁄
5
8
" off the insert ring and tighten the motor-clamp screw.
Motor Diameter
4.2"
4.143"
3.267"
3.32"
3.5"
3.625"
3.675"
3.218"