Senix GTBCU4QL-M Manual Del Operador página 22

Long-term Storage
1. Remove the fuel cap, tip the unit and drain the fuel into
an approved container. Reinstall the fuel cap.
2. Start the engine and allow it to run until it stalls.
This ensures that all fuel has been drained from the
carburetor.
3. Allow the engine to cool. Remove the spark plug and put
5 drops of any high quality motor oil into the cylinder.
Pull the starter rope slowly to distribute the oil. Reinstall
the spark plug.
4. Thoroughly clean the unit and inspect it for any loose or
damaged parts. Repair or replace damaged parts and
tighten loose screws, nuts or bolts.
5. Store the unit in a horizontal position. If horizontal
storage is not possible, store unit vertically with engine
at top.
Preparing The Unit For Use after Long-Term Storage
1. Remove the spark plug. Tip the unit and drain all of
the oil from the cylinder into an approved container.
Reinstall the spark plug.
2. Change the oil. Refer to Changing the Oil.
NOTE:
Do not use fuel that has been stored for more than 30 days.
Dispose of old fuel and oil according to federal, state and
local regulations.
TRANSPORTATION
Transport the unit in a horizontal position. If not possible,
transport the unit vertically with the engine at the top.
Secure the trimmer shaft to prevent damage during
transport.
EN - 22 WWW.SENIXTOOLS.COM