Worx WX852 Manual De Instrucciones página 11

12v vehicle.
2. When use the jump starter to
start a car, check the remaining
capacity is at least 3 LEDs on and
the machine is cool down.
3. Disconnect the clamp from jump
starter and vehicle immediately
after every start attempt. Do
not use it to start the vehicle
frequently. Each attempt allow at
least 30s to rest.
4. Please charge the jump starter
at least once a month and do
not charge it when it is hot or
immediately after each use.
5. Do not allow the mental teeth of
the red clamp to touch the black
clamp.
6. Keep the jump starter from
children.
7. Do not dissemble the jump
starter.
8. Do not insert foreign objects into
any input or output ports.
9. Do not put the jump starter in
extreme environment where the
temperature and humidity is high.
10. If you find the jump starter
inflates, please stop use and send
it to the authorized service center.
11. The device shall be stored indoors
and protected from the elements;
12. The unit shall not be charged
outdoors;
13. When in use, steps should be
taken to reduce the exposure to
rain, sleet, snow, and the like.
1. CHARGING
NOTE: Upon initial use, your jump
starter should be charged for a
minimum of 4 hours.
MULTI FUNCTION 4L JUMP
STARTER WITH LED LIGHTS
CHARGE STATUS INDICATION
Press the Power Button one time
to see the unit's state of charge.
The unit's state of charge status is
indicated by four LED indicators
below the Power Button, as follows:
One LED on= Recharge Immediately
Two LEDs on= 25-50% Charge –
Charge soon
Three LEDs on= 50-75% Charge –
Charge if using as a jump starter
Four LEDs on= At or near full charge
Note: When starting up as a battery,
it is recommended that the jump
starter be in or near 100% charge
state, at least three grids of charge.
CHARGING INSTRUCTIONS (SEE
FIGURE A1)
1. Connect the pin jack to the jump
starter through the input port.
2. Connect the USB power connector
to the AC adapter.
3. Plug the AC adapter into the
power supply.
Charging with the Car Charger
(SEE FIGURE A2)
1. Connect the car charger and the
car charging cable, then connect
the jump starter through the
cable.
2. Insert the car charger into 12V car
receptacle.
Note: The LEDs will turn on
successively to indicate charging
progress. When all LEDs are lit solid,
the unit has reached full charge.
2. Starting the vehicle
Note: When starting the vehicle,
make sure that the unit is charged
such that the unit's Status Display
shows 3 LEDs when the Power Button
11
EN