Publicidad
Idiomas disponibles
Idiomas disponibles
Over-Temperature
Protection
Trouble Shooting
1. The indicator light does not show
when charging the device
1) Check that the charging cable is
actually connected to the device.
2) Check if the port is correctly
connected.
2. Flashlight can't open
1) Check if the device has enough
charge for use.
2) Check that it is used correctly.
3. Unresponsive when using the
device
1) Charge the device, when charging,
14
the light flashes
2) If an emergency start is given
to a car device with low battery
capacity, the start is not valid due
to the activation of the chip safety
protection function. It can be reset
by charging it to be reactivated.
MAINTENANCE AND
STORAGE
Your tool requires no additional
lubrication or maintenance. Never
use water or chemical cleaners to
clean your charger. Wipe clean with a
dry cloth. Always store your charger
MULTI FUNCTION 4L JUMP
STARTER WITH LED LIGHTS
≥ 60℃, then shut down
RED LED blink with buzzer
shouts twice (0.2s apart), after
1s gap, shouts twice again
(ibid.), and so on
in a dry place.
Long time not used, it is
recommended to maintain a certain
capacity of the battery.
PRECAUTIONS
1) The applicable temperature for
o
o
use -17
C -40
2) Avoid direct sunlight or humid
conditions.
3) Avoid the switch being squeezed
when placed.
4) If circuit protection is caused
by plugging in high-power 12V
vehicle equipment (current more
than 8A), charge the emergency
power supply to activate it.
C
EN
Publicidad
