Ego Power+ FN1800E Manual Del Usuario página 9

Fully charge before first use.
To attach
1. Pull the battery compartment cover to open it.
2. Align the battery ribs with the mounting slots and
press the battery pack down until you hear a "click".
To detach
1. Depress the battery-release button and lift the
battery pack out.
2. Push the battery compartment cover to close it.
Ensure that it is completely closed to prevent water
from contacting battery or entering battery port.
Fig. E parts description see below
E-1 Battery Release Button
E-2 Battery Compartment Cover
TO START/STOP THE MISTING FAN
NOTICE:
The initial factory setting for the air speed is
level 3. The fan will save the last used air speed setting
and will revert to it upon restart.
IMPORTANT:
Turbo setting will not be saved.
NOTICE:
The misting setting will not be saved, and by
default will be off every time the fan is turned on.
POWER BUTTON
◾
Press the power button briefly to turn the fan ON.
◾
Press the power button briefly again to turn the fan
OFF.
AIR SPEED ADJUSTMENT
Normal Air Speed
◾
Press the "+" button to accelerate the air speed and
press the "-" button to decrease the air speed. There
are 5 speed levels.
◾
The air speed indicator displays green lights
corresponding to the current speed levels.
TURBO Mode
◾
Press the "TURBO" button, the TURBO indicator will
light up green and the fan will shift into "TURBO"
mode, i.e. the highest air speed.
◾
When in "TURBO" mode, press "TURBO" button again,
the TURBO indicator will turn off and the fan will
resume the previously active air speed.
◾
When in "TURBO" mode, press "-" button, the TURBO
indicator will turn off and the fan will shift to the air
speed level 5.
MISTING FUNCTION
USING THE FAN WITH A WATER BUCKET (NOT INCLUDED)
(Fig. F)
WARNING:
Keep children away from buckets containing even a small
amount of liquid.
NOTICE:
each use.
1. Disconnect the battery pack.
2. Place the bucket on a flat, level surface.
3. Add ONLY clean, cold water into the bucket. Do not
overfill.
4. Immerse the filter end of the intake tube down into
the water bucket.
NOTICE:
sure the water flows smoothly through the tube.
5. Install the battery pack and close the battery
compartment cover.
6. Press the power button to turn the fan ON.
7. Press the misting mode selection button to start
misting:
◾
Press the misting mode selection button once and
the misting indicator will light up two green lights
which indicates the 'continuous' misting mode -
misting all the time without stopping.
NOTICE:
you actually see the mist coming out of the misting
nozzles the first time. This delay is due to the time
it takes for water to flow from the water bucket to
the nozzles.
◾
Press the misting mode selection button again and
the misting indicator will light up one green light
which indicates the 'intermittent' misting mode -
misting for 5s every 10s.
◾
When the misting is in intermittent mode, press
the misting mode selection button again and the
misting indicator lights will turn off and the misting
will stop.
56 VOLT LITHIUM-ION CORDLESS MISTING FAN — FN1800E
Children can fall into buckets and drown.
Clean the bucket with soap and water before
Do not bend the intake tube, and always make
It may take around 15 seconds before
EN
9