Manual Adjustment; Electronic Adjustment - Zanussi ZDV 14001 Manual De Instrucciones

Manual adjustment

1

Electronic adjustment

1. Press the on/off button to activate the appli-
ance.
2. Make sure that the appliance is in setting
mode. Refer to 'SETTING AND STARTING
A PROGRAMME'.
3. Press and hold function buttons (B) and (C)
at the same time until the indicators of func-
tion buttons (A), (B) and (C) flash.
4. Press function button (A).
• The indicators of function buttons (B)
and (C) go off.
• The indicator of function button (A) con-
tinues to flash.
• Intermittent acoustic signals operate and
the end indicator flashes showing the
setting of the water softener.
– The number of flashes of the end indi-
cator and the number of the acoustic
signals show the level of the water
softener.
Example: 5 acoustic signals and 5
flashes + pause + 5 acoustic signals
and 5 flashes = level 5.
5. Press function button (A) again and again
to change the setting. Each time you press
function button (A) you go to the next level.
6. Deactivate the appliance to confirm.
20
2
Turn the water hard-
ness dial to the posi-
tion 1 or 2.
Filling the salt container
Caution! Only use dishwasher salt. Other
products can cause damage to the
appliance.
Water and salt can come out from the salt
container when you fill it. Risk of corrosion. To
prevent it, after you fill the salt container, start a
programme.
1
3
Put 1 litre of water in
the salt container (on-
ly for the first time).
5
Filling the rinse aid dispenser
Caution! Only use rinse aid for
dishwashers. Other products can cause
damage to the appliance.
2
4
6
www.zanussi.com