Setting Mode - Zanussi ZDV 14001 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Do not use more than the correct quantity
of detergent. Refer to the instructions on
the detergent packaging.
1
3
4
Detergent tablets do not fully dissolve with
short programmes and detergent residues
can stay on the dishes.
We recommend that you use detergent tablets
with long programmes.
Combi detergent tablets
These tablets contain detergent, rinse aid and
other added agents. Be sure that these tablets
22
2
5
If the programme has
a prewash phase, put
a small quantity of
detergent on the in-
ner part of the appli-
ance door.
are applicable to the water hardness in your
area. Refer to the instructions on the packaging
of the products.
When you use tablets, that contain salt and
rinse aid, do not fill the salt container and the
rinse aid dispenser. The rinse aid indicator al-
ways comes on if the rinse aid dispenser is
empty.
1. Adjust the water softener to the lowest lev-
el.
2. Set the rinse aid dispenser to the lowest
position.
If you stop to use the combi detergent
tablets, before you start to use separately
detergent, rinse aid and dishwasher salt,
do these steps:
1. Press the on/off button to activate the appli-
ance.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the
rinse aid dispenser are full.
4. Start the shortest programme with a rinsing
phase, without detergent and without
dishes.
5. Adjust the water softener to the water hard-
ness in your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme

Setting mode

The appliance must be in setting mode to ac-
cept some operations.
The appliance is in setting mode when, after
the activation:
• All the programme indicators come on.
If the control panel shows other conditions,
press and hold function buttons (B) and (C) at
the same time until the appliance is in setting
mode.
Starting a programme without delay start
1. Open the water tap.
2. Press the on/off button to activate the appli-
ance. Make sure that the appliance is in set-
ting mode.
www.zanussi.com

Publicidad

Tabla de contenido
loading

Tabla de contenido