Sony KL-X9200J Manual De Instrucciones página 11

Connect ing t o video equipm ent
To a VCR not equipped w it h an S video
connect or
Rear of the monitor
to VIDEO 1 IN or
VIDEO 3 IN
VM C-810S/ 820S
(not supplied)
You can also use the VIDEO 2 IN jacks on the front of
the monitor for the video/audio connections.
To an S video equipped VCR
Rear of the monitor
to VIDEO 1 IN or
VIDEO 3 IN
YC-810S
(not supplied)
Downloaded from: https://www.usersmanualguide.com/
VIDEO IN VIDEO
COMPONENT IN
1 3
OUT
Y
S VIDEO
P /C /B-Y
B B
VIDEO
P /C /R-Y
R R
L
L
AUDIO
AUDIO
R
R
to video/ audio outputs
VCR
VIDEO IN VIDEO
COMPONENT IN
1 3
OUT
Y
S VIDEO
P /C /B-Y
B B
VIDEO
P /C /R-Y
R R
L
L
AUDIO
AUDIO
R
R
to S video/ audio outputs
VCR
Not es
• You can also use the S VIDEO connector on the VIDEO 2 IN
panel on the front of the monitor.
• When you connect the cable to both the VIDEO jack and the S
VIDEO connector, the picture from the S VIDEO connector is
displayed on the monitor screen.
Connect ing t w o VCRs f or edit ing
The monitor outputs the signal input from the VIDEO 1
IN, VIDEO 2 IN or VIDEO 3 IN jacks through the
VIDEO OUT jacks. With two VCRs connected to the
VIDEO IN and VIDEO OUT jacks, you can edit a tape.
Not es
• Signals input from the RGB 1 IN, RGB 2 IN and COMPONENT
IN connectors are not output through the VIDEO OUT jacks.
• Do not connect both the VIDEO IN and VIDEO OUT jacks on
this monitor simultaneously to the video/audio output and
input jacks on a single VCR.
• If no signal is input to the S VIDEO connector on any of the
VIDEO 1, 2 and 3 IN panels, the S VIDEO connector on the
VIDEO OUT panel does not output a signal.
Rear of the monitor
VIDEO IN
1
S VIDEO
to VIDEO 1 IN
VIDEO
or VIDEO 3 IN
L
AUDIO
R
VM C-810S/ 820S
(not supplied)
to video/ audio
outputs
VCR for playback
VIDEO
3
OUT
to VIDEO OUT
VM C-810S/ 820S
(not supplied)
to video/
audio
inputs
VCR for recording
11
Get t ing St art ed -GB
GB