Sony KL-X9200J Manual De Instrucciones página 29

Troubleshoot ing
If the problem persists after trying the methods below,
contact your nearest Sony dealer.
No pict ure
Check that the power cord is connected
/
firmly.
Is the power of the monitor turned on?
/
Is the air filter mounted securely? (page 27 )
/
Is the lamp cover attached securely? (page
/
28 )
Check that the power of the connected
/
equipment is turned on.
Try to press any key on the connected
/
computer's keyboard.
Check that the RGB signal cable or audio/
/
video cords are properly connected. (The
supplied HD15-HD15 adaptor may be
needed for some models of IBM PC/AT or
compatible computers. For a Macintosh or
compatible computer, use the supplied
Macintosh adaptor.) (pages 7 and 8 )
Make sure that no pins on the HD15
/
connectors are bent.
Check that the connected computer's video
/
card is seated completely in the proper bus
slot.
Check that the frequency range of the input
/
signal is within that specified for the
monitor. (If not, "OUT OF SCAN RANGE"
appears on the screen.) (page 9 )
The monitor does not accept an interlace
/
mode signal that is not a preset mode
signal.
For customers using Windows 95/98 — If
/
"KL-X9200" is not displayed as "Monitor
type" in the device selection screen in
Windows 95/98, select "Plug and Play
monitor (VESA DDC)" as "Monitor type."
Downloaded from: https://www.usersmanualguide.com/
Pict ure and sound out put are delayed
When the green u (power) indicator on the
/
front is flashing, the monitor is warming
up.
To protect the lamp, the monitor does not
/
immediately output the picture and sound
if you try to turn on the power more than 5
seconds after the power has been turned
off.
Good pict ure, no sound
Press VOL+ (VOLUME+).
/
Press MUTING so that "MUTING"
/
disappears from the screen. (page 16 )
The volume of the computer may be low.
/
Check that the audio connecting cord is
/
connected firmly to the audio outputs on
the computer.
Fuzzy pict ure
If you use the monitor in a cold place,
/
moisture condensation may have occurred.
Leave the monitor as it is to let the
moisture evaporate.
Dark pict ure
Replace the lamp for the light source with a
/
new one. (page 28 )
No color, abnorm al color
Adjust the picture in the VIDEO ADJUST
/
menu. (pages 20 and 21 )
Select an appropriate color system from the
/
COLOR SYSTEM option in the OPTION
menu to obtain optimum color.
Com put er pict ure not clear
Adjust PITCH, then PHASE in the DOT
/
ADJUST menu. (page 18 )
Horizont al lines of t he com put er pict ure are
not visible.
Check that TIMING in the DOT ADJUST
/
menu is set to YES. (page 18 )
Com put er pict ure not cent ered or sized
properly
Adjust the centering and size so that the
/
picture fits the screen. (pages 16 and 17 )
Addit ional Inf orm at ion
GB
(cont inued)
29
-GB