Sony KL-X9200J Manual De Instrucciones página 30

Dist ort ed pict ure
Check your video card manual for the
/
proper monitor setting.
Check that the frequency and the graphic
/
mode of the signal you are trying to input
is within the acceptable range. (page 9 )
Even if the signal is within the proper
range, some video cards may have a sync
pulse that is too narrow for the monitor to
sync correctly.
No pict ure, no sound f rom t he connect ed
equipm ent
Are all of the cords connected correctly?
/
Press the RGB, VIDEO or COMPONENT
/
button on the remote control. (page 15 )
The rem ot e cont rol does not f unct ion.
Are the batteries worn out?
/
If additional equipment is connected to the
/
CONTROL S IN jack on the rear of the
monitor, the remote control detector does
not function. Disconnect any equipment
connected to the CONTROL S IN jack.
(page 13 )
The hum m ing noise of t he f ans is heard even
af t er t he m onit or has been t urned of f .
The fans installed inside the monitor are
/
working to prevent internal heat build-up.
They will stop in about 2 minutes.
30
-GB Addit ional Inf orm at ion
Downloaded from: https://www.usersmanualguide.com/
What t he indicat ors on t he f ront of t he
m onit or m ean
LAMP STANDBY
The u (power) (green), STANDBY (orange) and/or
LAMP (orange) indicators indicate the condition of the
monitor and provide warnings by lighting or flashing,
as shown below.
The u indicat or light s up.
The power of the monitor is on.
/
The STANDBY indicat or light s up.
The monitor is in standby mode. The
/
monitor is turned on by pressing 1/u on
the remote control.
The u and STANDBY indicat ors light up.
The AUTO SHUT OFF function is working.
/
The monitor has been turned off when the
time you specify has passed after the input
from the computer is cut off.
The u indicat or f lashes.
The lamp is preparing to turn on. Picture
/
and sound will appear momentarily.
The LAM P and STANDBY indicat ors f lash.
The air filter or the lamp cover is not
/
attached securely. When you secure the
cover, the STANDBY indicator lights up
and the LAMP indicator turns off. (pages
27 and 28 )
The LAM P indicat or f lashes.
The lamp for the light source has burnt out.
/
Replace it with a new one. (page 28 )
The LAM P, STANDBY and u indicat ors f lash.
The LAM P and u indicat ors f lash.
The STANDBY and u indicat ors f lash.
Contact qualified Sony personnel and
/
inform them of the monitor's condition.