Publicidad
Idiomas disponibles
Idiomas disponibles
OILFEEDING
CAUTION: prior to oil feeding, always disconnect the plug from the power supply receptacle.
1. Chamber is built in this Electric Hammer, it can be used for approximately 20 days without suppl-
ying lubricating oil, assuming that the Hammer is used continuously 3~4 hours daily.
2. Feed oil into the oil tank as described below before using this Hammer. Just before no oil is
visible in the oil gauge windows when the device is held upright, feed oil to warm it up.
Before feeding oil, use the provided wrench to remove the oil gauge. Be careful not to lose the
rubber packing attached below the oil gauge.
3. Check the oil level once daily, confirming that oil is filled.
4. After feeding oil, securely clamp the oil gauge.
NOTE: As an optional accessory, oil for the Electric Hammer (one liter) is sold separately. Use this
oil when oil when oil in the tank is depleted. Shell Oil Co. ROTELLA #4(engine oil ） can also be used.
This oil is sold as Shell filling stations most anywhere.
CHANGE MOTOR
CAUTION: Always be sure that the tools is switch off and unplugged before attempting to perform
inspection or maintenance.
Use the screw driver to open the button. Take out broken motor. The way is same as change brush.
7/64"
Resupply oil when the oil level drops to less
than approx. 7/64"
Hex wrench 5
Motor house cover
9
Publicidad
