Publicidad
Idiomas disponibles
Idiomas disponibles
d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the
power tool or these instructions to operate the power tool. power tools are dangerous in the hands
of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and
any other condition that may affect the power tools operation .If damaged, have the power tool
repaired before use. Many accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc., in accordance with these Instructions and in
the manner intended for the particular type of power tool tacking into account the working condi-
tions and the work to be performed. Use of the power tool for operations different from intended
could result in a hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
WARNING! The use of any accessory or attachment, other than recommended in this instruction
manual, may present a risk of personal injury. Have your tool repaired by a qualified person.
This electrical tool is in accordance with the relevant safety requirements. Repairs should only be
carried out by qualified persons using original spare parts; otherwise this may result in considerable
danger to the user.
3. APPLICATION
Before plugging in, make sure that the network's voltage and frequency correspond to those indica-
ted on the tool's ratings plate; and that the ON/OFF button did not remain blocked. The tool opera-
ted, or is in "ON" position when the trigger(F) is pressed and comes back to the" stop" position
when the same trigger is released. Always hold the tool firmly with both hands, with handles(A)and
(B), while operating.
It is sometimes necessary to apply force on the point of the drill spindle so that the percussion
system may operate otherwise the protection device against off-load operating passes into action.
Adopt a moderate workload; the use of too much force alters safety and efficiency.
Changing tools
Unplug the tool from the power supply, only use drill spindles compatible with the tool.
3-1) Mounting clean the drill spindle before use and lightly oil the special imprint. Pull and turn the
lock (C) 180℃ clockwise. insert the drill spindle (D) in the hexagonal housing, the slot on the lock
side. Pull and turn lock (C)180℃ anticlockwise. Pull the drill spindle to check that it can only have a
translation movement translation of about 3 cm.
3-2） Dismantling proceed in reverse order to mounting.
4) Lubrication-oil level
before completing the oil level, unplug the tool from the 230V network. The oil weir offers autonomy
of 20 days based on a continuous use of 3 hours a day. But check the oil level every day .Just
before the oil level is no longer visible in the gauge window (G) by holding the tool vertically (the
drive spindle downwards） ,proceed to flitting the oil reservoir. Remove the oil gauge (G) with the
spanner supplied ,watch out not to damage or loose the gasket. Fill the reservoir with type #40 oil
(motor oil) Place the gauge back.
4
Publicidad
