Wall Mounting - Bosch GAL18V-40 Instrucciones De Funcionamiento

2610051857.qxp_GAL18V-40 1/8/19 10:50 AM Page 7
IG. 2
mounting hardware prior to drilling hole.
Note: The consumer is responsible for
damage or injury caused by incorrect
installation.
Use mounting
appropriate for the wall type and suitable
for the weight of charger and heaviest
battery pack. If the charger is installed
without the correct hardware, the product
may be unstable and cause property
damage or personal injury.
Do not wall mount the charger where the
weight of the charger and battery cannot
be supported. If the strength of the wall
mount location is not strong enough, the
charger can fall off and cause an injury.
Note: It is the consumer's responsibility to
ensure that the wall can properly support
the total weight.
Check to be sure that there are no hidden
live wires, water pipe, or gas pipe behind
the mounting area. Cutting or drilling into
any of these may cause serious injury or
death.
vertical wall. Mounting of the charger is
designed for vertical surfaces only.
Improper installation may cause property
damage or personal injury.

Wall Mounting

Read instructions of the
drill driver and the
hardware which
Do not mount to any
surface other than a
5
5
The charger can be mounted to a wall using
wall mounting slots 5 (Fig. 2).
a. Locate mounting area on the wall.
b. Mark two points on a vertical line
2.84" (72mm) apart.
c. Select the appropriate screws and
is
anchors (if necessary) for the material
of the wall. (Mounting hardware not
included.)
d. Drill into wall with appropriate drill
bit. If anchors are to be used, follow
anchor hardware manufacturer's
instructions.
e. Screw in two round-head screws (not
included) with a diameter of 0.2"
(5mm) to maximum 0.25" (6.5mm)
into wall
approximately 0.13" (3.3 mm) space
between bottom of screw head and
wall.
f. Position the charger screw slots over
the mounting screws. Push charger
towards the wall and slide it down to
secure charger to mounting screws.
Note: Make sure the charger is securely
mounted and that it is tight against the
mounting surface. Adjust screw exposure
as necessary to ensure the charger is flat
against the wall.
7
2.84"
(72mm)
or anchors. Leave