Profi Cook PC-WKS 1192 Manual De Instrucciones página 9

Electrical Connection
1. Check that the mains voltage you want to use matches
that of the appliance. You will find the information on the
type plate.
2. Only connect the appliance to a properly installed protec-
tive contact socket.
Switching the Appliance On / Off
• Switch on:
Switch on the appliance with the switch. The control
lamp lights up.
• Switching off:
Switch off the appliance with the switch. The control lamp
goes out.
Preparation
Before using the appliance for the first time, boil it 3 times
with fresh water. Use only clear water without additives.
Operation
1. Place the appliance on a flat surface.
2. Also hold the kettle by the handle and open the lid.
3. Fill in clear water through the filler opening (maximum
1.7 litre). You can read the fill level on the appliance's
water level indicator.
- Always use fresh, cold water.
- The water level must be between the MIN and MAX
marks.
WARNING:
• Always switch off the appliance and disconnect the mains plug
from the socket before cleaning. Wait until the appliance has
cooled down.
• Do not immerse the appliance or the base in water or other liq-
uids. It could cause an electric shock or fire.
CAUTION:
• Do not use a wire brush or other abrasive objects.
• Do not use sharp or abrasive cleaning agents.
• Rinse the water reservoir with clean water. Dry it with a
cloth.
• Clean the housing with a slightly damp cloth after use.
PC-WKS1192_IM_03.2023
4. Close the appliance with the lid. It must audibly click into
place. Always make sure that the lid is firmly closed.
5. Place the appliance flush onto the base.
6. Switch on the appliance with the switch. The control
lamp lights up.
- The water temperature can be seen on the display.
Interrupting / Ending Operation
There are two ways to interrupt or end the cooking process:
1. The appliance switches off automatically after the cook-
ing process. The control lamp goes out.
2. Press the switch upwards to stop the cooking process.
- Always switch off the appliance before removing
it from the base! The contacts on the base are not
suitable for disconnecting the power supply.
- Make sure that the appliance is switched off when you
put it back on the base!
• Unplug the mains plug from the socket.
• Empty the water container.
- Only hold the appliance by the handle.
- Keep the lid closed when pouring out.
- Always open and close the lid with the handle on the
lid.
• The appliance becomes hot during operation, do not
touch it and allow the appliance to cool down before
putting it away.
Cleaning
Filter
A permanent filter is located at the spout opening. To clean
the filter, remove it from the kettle.
• Rinse the filter out under running water. Clean it with a
nylon brush if it is necessary.
• Re-insert the filter. To do so, use the guides on the inside
of the kettle. The filter must click audibly into place.
9
24.03.23