Rampage Products 26410031 Instrucciones De Instalación página 2

2
Remove the middle and rear body mount bolts.
Save Hardware.
See Figure 2
NOTE: There is a plastic keeper in the body
mount that prevents the bolt from falling out if
it were to come unthreaded. A prybar may be
required to finish pulling the bolt all the way out
after being fully unthreaded.
3
Remove the nuts on the middle and rear body
mount alignment nuts.
Save Hardware.
See Figure 3
4
Fit a plastic keeper onto the bolt of the bolt plate.
Make sure the plastic keeper is all the way up
against the plate.
See Figure 4
5
Place the bolt plate and plastic keeper into the
large slot in the frame.
See Figure 5
NOTE: Make sure the bolt plate and plastic
keeper are snug against the frame.
Figure 2
Figure 3
Figure 4
Figure 5
Page 2 of 4