Herschel FLORIDA 2000 Manual De Instrucciones página 4

The sides and ends of the heater must always be at least 300mm (12") away from the nearest wall, ceiling
or other structure. The unit has a tip over protection which will turn the heater off if tilted beyond a 45
degree angle. If possible, bolt the base to the floor to avoid the risk of the heater being accidentally
knocked over.
CAUTION:
• Ensure mains power is OFF and the unit is cool before handling.
• Heater must not be located immediately above or below a socket outlet. Electrical connections must
be made outside of the footprint of the unit to avoid heat build-up in the connection.
• The identification mark and model reference should be visible after installation.
• The fixed wiring insulation coming into contact with parts with a temperature rise of greater than 50°C
must be protected, for example, by sleeving having an appropriate temperature rating.
Ensure that wires are properly secured and cannot be pulled by small children.
•
ASSEMBLY:
Step 1. Fit the base
Parts supplied:
01 Rubber foot pieces
02 Hex-headed bolt
03 Spring washer
04 Area washer
X5
X3
X3
X6
ENGLISH