Mitsubishi Electric Mr.SLIM PSA-MKA Serie Manual De Instalación página 17

6. Electrical work
Language selection
English
Español
Português
Türkçe
Select:
Cursor
Auto mode
Select:
Wi-Fi interface setting
Ref. address
Function
Connect:
Cursor
Wi-Fi interface setting
Ref. address
Function
Connecting···
Please start router WPS
within 2 minutes.
Cancel:
Wi-Fi interface setting
Ref. address
Function
Setting display:
Français
Italiano
Ελληνικά
Svenska
Cursor
Auto mode
Yes / No
Cursor
Router WPS
Address
Router WPS
Router WPS
Completed
(5) Language selection
[Button operation]
Move the cursor to the language you desire with the F1 through F4 buttons.
Press the SELECT button to save the setting.
Operation setting menu
(1) Auto mode setting
[Button operation]
Whether or not to use the Auto (single set point) or Auto (dual set points) mode can
be selected by using the F3 or F4 button. This setting is valid only when indoor units
with the Auto mode function are connected. (The factory setting is "Yes".)
Press the SELECT button to save the changes made.
• Yes: The Auto mode can be selected in the operation mode setting.
• No: The Auto mode cannot be selected in the operation mode setting.
Wi-Fi interface setting
This setting needs to be made only when connecting a separately sold Wi-Fi interface.
(1) Router connection
[Button operation]
1 Press the F1 or F2 button to select "Ref. address" then "Function."
Press the F3 or F4 button to select the desired settings.
• Ref. address: 0 to 15
• Function: Router (WPS)/Router (AP)
2 Press the SELECT button. "Connecting..." will appear.
• Router (WPS): Press the WPS button on the Wi-Fi router within 2 minutes.
• Router (AP): Make the network settings by referring to the manual for the cloud
service within ten minutes.
When router connection has been established, "Completed" will appear. If a mes-
sage other than "Completed" appears, check the connection, and start over from
Step 1, or refer to the Wi-Fi interface manual.
Select "Request code" from the Check menu to display or set the following items.
Function Request
code
Displays the Wi-Fi interface 504
status
Resets the Wi-Fi interface 505
Resets the Wi-Fi interface to 506
the factory settings
Send results
00: Not connected. The interface
has been reset. The interface
has been reset to the factory
settings.
01: WPS mode
02: AP mode
03: Connecting...
"Communication completed" will
appear when the interface has been
reset.
"Communication completed" will
appear when the interface has been
reset.
15
en