Anker Y1010 Manual Del Usuario página 25

問題 3：為什麽充電座正面的 LED 燈會閃爍？
充電座正面的左右 LED 燈指示遊戲手柄的充電狀態。如果有一個或兩個都
在閃爍，可能是由於以下情況之一：
1. 充電功率小於 15W 和 / 或遊戲手柄內部沒有電池或電池不匹配：請使用
輸出功率至少為 15W 的充電器，並使用遊戲手柄隨附的充電電池。
2. 觸發了溫度保護：取下遊戲手柄後冷卻 5 到 10 分鐘，然後重試。
3. 電池未正確放入遊戲手柄或遊戲手柄未正確放到充電座上：確保電池的
金屬部分接觸到遊戲手柄的接觸板，並且遊戲手柄的銅板接觸到充電座
的彈簧針。
4. 氧化物或汙垢阻礙充電：使用幹布蘸酒精清潔遊戲手柄的銅板、充電座
的彈簧針和電池的接觸部分。
註意：
• 不附帶 Oculus Quest 2 和 Touch 遊戲手柄。
• 不適合用於帶電池的 Oculus Elite Strap。
• 充滿電後，Anker 充電座會將 Quest 2 遊戲手柄的電量保持在略低於
100% 的水平，以最大限度地延長電池壽命和性能。
• 如果您在 Quest 2 頭戴設備或遊戲手柄上使用保護套， 請在充電前取下。
• 要同時為頭戴設備和遊戲手柄充電，請使用隨附的充電器。使用輸出功
率小於 15W 的充電器只能給頭戴設備充電。
• 橙色燈閃爍表示充電座已停止充電。請參見「常見問題」了解完整的詳
細說明。
• 請不要在電池發熱時將其取出，應等待電池冷卻後再取出。
45 TC
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
(3) Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
(4) Consult the dealer or an experienced radio / TV technician for help.
The following importer is the responsible party (for FCC matters only).
Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: +1-800-988-7973
Notice to canadian users
This device complies with Industry Canada license-ICES-003. Operation
is subject to the following two conditions: (1) This device may not cause
interference, and (2) This device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
46