Checking And Topping Up The Rear Brake Fluid; Bleeding The Rear Brake Fluid - DEFYGRAVITY SHERCO TY125 Manual De Propietario

Checking and topping up the rear brake fluid

A

Bleeding the rear brake fluid

C
WARNING
Brake fluid is highly corrosive, therefore remove any spillage that may have come into contact with
parts of the motorbike.
The rear brake fluid reservoir is located next to the
kick-start lever.
WARNING
To inspect the fluid correctly, make sure the
motorcycle is in an upright position.
To top up the fluid:
- Remove the threaded cap from the reservoir
- Remove the internal rubber and the pressure ring.
- Top up the fluid.
B
Type of brake fluid: DOT4.
WARNING
The brake fluid level must be between the MIN and
MAX marks
To bleed the rear brake system:
A
- Remove the reservoir cap (see previous section).
- Remove the black protective cap
- Press the rear brake pedal
- Slightly loosen the protected device
black bleed nipple positioned next to the hose
attachment.
- Repeat various times until the air has been
eliminated from the fluid circuit.
B
- Refit the black protective cap
- Refit the reservoir rubber and cap.
Place a cloth under the bleed nipple to absorb the
fluid.
.
B
TIP
.
A
.
A
and hold it down.
B
with the
C
.
A
57 57