Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Place the steering wheel cap over the center of the steering wheel and
push downward until it "clicks" into place.
Attaching The Seat
If the seat for your tractor was not attached at the factory, refer to the following
steps.
NOTE: For shipping reasons, the seat may have not been attached at the factory. In
this case, free the seat from its shipping position and proceed using the instructions
below:
4.
Position the seat assembly over the seat mounting bracket, aligning the holes
provided. See "A" in Figure 4.
5.
Install two shoulder bolts included with your hardware pack and secure with two
lock nuts. See Figure 4.
6.
Feed the wiring harness through the seat mounting bracket and plug into the safety
switch on the bottom of the seat, as in "B" of Figure 4.
7.
To adjust the position of the seat, pull up and hold the seat adjustment lever.
Slide the seat forward or rearward to the desired position; then release the
adjustment lever. Make sure seat is locked into position before operating the
tractor. See Figure 5.
WARNING! Before operating the tractor, make sure the seat is
engaged in the seat-stop. Engage the parking brake. Stand behind
the machine and pull back on seat until it clicks into place.
ASSEMBLY
Figure 3
B
Tire Pressure
Maximum tire pressure under any circumstances is 30 psi. Equal
tire pressure should be maintained at all times. Never exceed the
maximum inflation pressure shown on the sidewall of the tire.
The recommended operating tire pressure is:
•
Approximately 10 psi for the rear tires
•
Approximately 14 psi for the front tires
IMPORTANT: Refer to the tire sidewall for exact tire manufacturer's
recommended or maximum psi. Do not overinflate. Uneven tire pres-
sure could cause the cutting deck to mow unevenly.
10
A
Figure 4
Figure 5
WARNING
A
Publicidad
